Modular range:
Controllers based on a master/slave system, for BGV C1 qualified hoists. The master controller is a 4-way controller, which complies with all regulations, following the IEC and EMC as well as the strict BGV. With this type of controller Prolyte is not only ahead of regulations, but has a vanguard position compared to other control manufacturers as well.

Each master can control up to 3 slave controllers, thereby creating a 16-channel controller. The individual masters can be interconnected to serve a system up to 64 channels. All pre-selected hoists will be activated by one single run button. If the protection system of one of each hoist is activated, this will automatically deactivate the complete control system. A feature, which brings a high factor of safety into your control system and your truss structure.

4-way controller “master”, PLE-30-041
• Direct control (400-415V-3ph-50Hz)
• Pre selection facility for all units
• Output: 1 x Harting 16p connector for hoist connection
• Input power: 100 cm power cable with 1 x CEE 32A-5p plug with phase reverse
• Short circuit protection for power and control
• Phase reverse or failure detection
• Emergency stop button
• Road proof steel 19”4U rack housing
• Master/slave link connection
• Adjustable thermal circuit breaker per hoist with reset function



4-way controller “slave”, PLE-30-042
• Direct control (400-415V-3ph-50Hz)
• Pre selection facility for all units
• Output: 1 x Harting 16p connector for hoist connection
• Input power: 100 cm power cable with 1 x CEE 32A-5p plug with phase reverse
• Road proof steel 19”4U rack housing
• Adjustable thermal circuit breaker per hoist with reset function